Blogue

New development snapshots

I put new development snapshots online for both OpenSCAD and FreeCAD. There is not much new functionality, but a few bugfixes that were contributed.

Main improvements:

  • some fixes for using BOLTS for FreeCAD on Arch Linux (contributed by Jon Nordby)
  • a fix that caused bearings come out too thick in FreeCAD (contributed by kkoksvik)

There was also a small but steady influx of suggestions for French translations in weblate, that I have continuously integrated. The translations are not yet used for the FreeCAD and OpenSCAD backends, but only show up on the website.

Commentaires